Differences

This shows you the differences between two versions of the page.

--- yeasu-ft857d [2026/02/02 18:43] – n3vem
+++ yeasu-ft857d [2026/02/02 18:47] (current) – n3vem
@@ Line 1: / Line 1: @@
-The 857d works well using a Signalink audio interface
+====== 857d Radio and Interface Settings ======
-===== Radio Settings for HF Packet =====
-Menu 001: EXT MENU set to ON
-Menu 037: DIG GAIN set to 15 (Exact value can be fined tuned here, Signalink TX Know, or PC Audio Device Settings)
-Menu 038: DIG MODE set to PSK31-L
-Menu 075: RF POWER SET as desired
-Multi-Function Row P: Make sure DSP settings are off.
+===== Radio Settings for HF Packet =====
+  * Menu 001: EXT MENU set to ON
+  * Menu 037: DIG GAIN set to 15 (Exact value can be fine tuned here, Signalink TX knob, or PC audio device settings)
+  * Menu 038: DIG MODE set to PSK31-L
+  * Menu 075: RF POWER SET as desired
+  * Multi-Function Row P: Make sure DSP settings are off.
 ===== Signalink Device Settings =====
@@ Line 13: / Line 13: @@
 Open up the Case by taking out the screws on the front panel, and sliding everything out the front.
-Install Jumper Wires per manufacturers directions for use with an 857d.
+  * Install Jumper Wires per manufacturers directions for use with an 857d.
-Place the jumper across both pins of JP2
+  * Place the jumper across both pins of JP2
-Place the jumper across both pins of JP4
+  * Place the jumper across both pins of JP4
-The Jumper should only be on 1 pin of JP3
+  * The Jumper should only be on 1 pin of JP3
 these instructions and a basic diagram are available here: [[https://www.qsl.net/na4it/slusb/slusb_ft857d.html]]